1. Welcome to the official forum for MINIX devices!
    Dismiss Notice

FW007А

Discussion in 'NEO U9-H Official Firmware Releases' started by Vladimir&69, Feb 20, 2018.

  1. Vladimir&69

    Vladimir&69 New Member

    Привет, как обновил эту прошивку произошла ошибка,сейчас черный экран с эмблемой minix больше не включается
     
  2. skynet

    skynet Moderator Moderator

    English please ;)

    Hi, as there was an error updating this firmware, now the black screen with the minix logo is no longer included



    Which box do you have ?
     
    kingsizept likes this.
  3. Vladimir&69

    Vladimir&69 New Member

    Minix u9h,сейчас ни как не получается прошить не через компьютер,не через usb,при включении черный экран и символ minix,восстановление не включается держу кнопку пуск 6 секунд не включается
     
  4. Villa

    Villa Administrator Administrator

    Still not English! o_O
     
    kingsizept likes this.
  5. Vladimir&69

    Vladimir&69 New Member

    Minix u9h
     
  6. skynet

    skynet Moderator Moderator

  7. Vladimir&69

    Vladimir&69 New Member

    При обновлении через компьютер произошла ошибка, после хотел установить старую прошивку, не установливается сейчас при включении черный экран
     
  8. skynet

    skynet Moderator Moderator

    If you want answers, write in english o_O
     
  9. Vladimir&69

    Vladimir&69 New Member

    when updating an error, now when you turn on the black screen is already the end or you can still revitalize
     
  10. skynet

    skynet Moderator Moderator

    Vladimir&69 likes this.
  11. Vladimir&69

    Vladimir&69 New Member

    when updating an error, now when you turn on the black screen is already the end or you can still revitalize
     
  12. skynet

    skynet Moderator Moderator

  13. Vladimir&69

    Vladimir&69 New Member

    Как отключить переводчик
     
  14. skynet

    skynet Moderator Moderator

  15. Vladimir&69

    Vladimir&69 New Member

    Ее установил и произошла ошибка
     
  16. Vladimir&69

    Vladimir&69 New Member

    Пишу на английском а переводчик переводит на русский
     
  17. skynet

    skynet Moderator Moderator

    Can you access to the recovery ?

    To go into the recovery mode of NEO U9 :

    1.) U9 is at OFF state with a power adapter attached.
    2.) U9 is attached to a display.
    3.) Press and hold the power button for 6 seconds to go into recovery mode.
    4.) Done.
     
  18. Vladimir&69

    Vladimir&69 New Member

    Не включается
     
  19. skynet

    skynet Moderator Moderator

    You PSU may be broken. Can you test with another one ?
     
  20. skynet

    skynet Moderator Moderator

    @Villa : is there a problem in this thread ? He write in english and it's automaticaly translated to russian. Perhap an issue with the integrated translator ?